Its taken me almost 6 months to get going - first race this weekend but have a prob.
Popped the engine in this weekend and I have a prob (I think) with the mesh on the gears. Pic attached and just wondered if this is OK or wether I need to bring forward a few mmm to be 100% in line - if so, how do I do it.
Oh, Losi8 1, Go engine...
Thanks in advance
Last edited by Bear; 26-05-2010 at 12:21 PM.
Hi Barney hows tricks??
Cant see your pic dude, can you re-attach it mate and we can have a look, however it sounds like your clutch bell needs shimming out to extend the bell to meet the spur.
Will be able to tell more when pic is up
Good thanks mate - been busy so taken ages to get going. Hopefull pic is up now.
you need a losi clutchbell fella, they are specific for losi only, you cant use normal bells.......
I might be wrong but dont you need the standard Losi clutch to run the Losi clutch bell??
It looks like you have a standard flywheel on there Barney and without have a mount that enables you to move your engine forward, you will need to get a Losi clutch and bell so it will mesh properly.
Also, take the blue collar off the clutch bell screw when you move it forward othewise you will go through your fuel tank
New clutch bell ordered from the friendly guys at BMM.
Still hopeful for that first race this weekend.
did you try changing the mount blocks around?