losi adjustable hinge pins settings

[Jimbo]

If you want to run the rear wish bones in the same postion as stock 2.0 you need to turn the rear plate upside down ie chassis locater upward.
This looks wrong but the wishbones sit lower at rear.
more kick up.
Jim

[Bazza]

No, the chassis has the kick up, what the instructions refer to with the "0" means you are running stock, if you use the other inserts you are "adding" or "subtracting" kick up, that's how I read it

Yeah that's what I meant...the chassis has the kick up but as for the pins by using '0' inserts effectively gives you 0 degrees kick up from the adjustable hinge pins - you can add more or less but the stock setting from the pins is '0' degrees.

I mean without adding it all up and just going on the pins and chart.

If you want to run the rear wish bones in the same postion as stock 2.0 you need to turn the rear plate upside down ie chassis locater upward.
This looks wrong but the wishbones sit lower at rear.
more kick up.
Jim

I don't understand the stock setting is 3 toe/ 3 anti-squat, the instructions say to achieve this use '0' in the front of the rear brace and '1 up' in the rear of the rear brace ~ I should of had a chat with you Sunday about this and a look at your's.

Nice to meet you again Jim btw Did you see my broken stock hinge pin holder? Fed up of replacing these and hinge pins...works out expensive so hopefully the problem will now go away now I have upgraded and I will be more careful/scared of breaking these adjustable ones

[Bazza]

This is what happened to my stock hinge pin holder after the crash(es)...



And this is what it done to my engine head

Adjustable braces now fitted without issues.

Thanks all!