Lrp trouble

[bubblev]

Hi all. Just wired a lrp x20 modified motor to a lrp spx stock spec esc. It all works fine exept the fact it runs in reverse. The wires are connected properly. Iv reset the esc programming. Iv tried swappin some wires on the offchance. I cant seem to get it working. Any ideas ppl ?

[night.freak]

Have you tried swaping the forward reverse switch on the Transmitter for the throttle that should do it?

[bubblev]

Yeah tried that it dies it swaps which way the throttle works. It still runs in reverse. Im at a loss

[bubblev]

All it does **

[Cwm2012]

Just swap over one of the outside cables on the motor to change direction.

[gregors]

Just swap over one of the outside cables on the motor to change direction.

+1

[davemate]

Just swap over one of the outside cables on the motor to change direction.

I think that only works on sensorless units if it's an lrp I am assuming it is sensored
Reversing the throttle channel on the tranny has always worked for me.

Hope you sort it.

[bubblev]

iv tried swapping the orange and yellow wires round, iv reversed the throttle on the tranny .. tried it all .... so if anyone has anymore ideas im all ears ...

[Chris]

Make sure the wires are connected up so A-A, B-B, C-C and also the sensor wire is connected

I would call S-M-D before you damage anything.

[83nji]

I did a bit of electric racing and I found that sometimes when I put in a particular battery, the car would run in reverse. Have you tried a different battery?

Ben